Water well drilling rig construction should also pay attention to reduce wear. Support sprocket, support wheel, drive wheel and rail chain link these are easy to wear parts, but, according to the implementation of daily inspection or not, there will be a large degree of difference. So, as long as a little bit of time spent on proper maintenance, can be very good control of its wear. If part of the support sprocket and support wheel can not operate under the state of continued use, it may cause roller wear deviation, but also may cause rail chain joint wear. If you find a roller that does not work, you must repair it immediately! In this way, other failures can be avoided. If you repeatedly walk on the inclined ground for a long time and turn suddenly, you will make the side of the rail link contact with the side of the drive wheel and the guide wheel, thus increasing the degree of wear. Therefore, the well drill rig should avoid walking and swerving in inclined areas as far as possible. Straight line and turn, can effectively prevent wear and tear.
Check the bolts and nuts carefully before using the drilling rig: the bolts and nuts will become loose due to the vibration of the machine during long working hours. Especially on the lower part of the walking body of the bolts and nuts, is easily affected. If the machine continues to operate under the condition that the bolts on the track plate are loose, a gap will occur between the bolts and the track plate, which will lead to cracks in the track plate. Moreover, the gap may also increase the bolt hole between the track and the track chain joint, resulting in the failure to tighten and must replace the track and the track chain joint serious consequences. Therefore, bolts and nuts should be regularly inspected and tightened to reduce unnecessary costs.
Before the use of the
water well drilling rig , the following parts shall be inspected and tightened: track plate bolts; Mounting bolts for supporting heavy wheel and supporting sprocket; Drive wheel mounting bolt; Walking pipe bolt, etc. Areas that do not require maintenance should also be examined.
In short, pay more attention to the use of the front track of the
water well drilling rig, such as whether the bolt is loose? Is the support sprocket and support wheel unable to rotate? Are the supporting sprocket, support and drive wheels leaking oil? If the above abnormal state is ignored, serious accidents will eventually occur. If the related parts are damaged and the supporting sprocket or support wheel is worn off due to bolt damage, the maintenance cost will be greatly increased.
