Notice:Welcome to Shandong China Coal Group! Credibility is life, the quality strives for survival" is the principle that all staff!
Position: Home » Product Wiki & Info » How to Use A Pneumatic Rock Drill

How to Use A Pneumatic Rock Drill

Pneumatic Rock Drill or air leg rock drill is one of the toughest and difficult to manage tools used in the construction industry to demolish old concrete. The pneumatic rock drill itself is really heavy so only appropriate personnel should handle the tools to reduce the risk of accidents.Rock drill have different tips and blades that should be installed depending on the type of job being performed. Let's go over the tips and tricks that will help you use the rock drill safely and easier.
When using either electrical or pneumatic drill be sure to:
1.Use the right PPE such as gloves, safety boots, ear protection and face protection at a minimum. It is important to use masks to water to eliminate fugitive dust and reduce exposure levels.
2.Workers should be rotated as possible to eliminate fatigue from workers that could lead to accidents at the jobsite.
3.The pneumatic rock drill being used will depend on the type of concrete being demolished as there are heavy and medium capacity pneumatic rock drill. Also the type of hose will vary depending on the pressure and type of action being performed.
4.Locate the pneumatic rock drill as near as possible to the work location, although the compressor should be as far as possible from the work area to reduce the level of noise.
5.Move the pneumatic rock drill properly by using the legs to avoid back strain or injuries.
6.Most pneumatic rock drill have a 'no load' safety device that will keep the drill from starting unless it is on a surface. To start the pneumatic rock drill push down against the surface firmly to start the tool.
7.Use the right point for the material to be broken. We recommend using rock point for rock, spade point for asphalt, and chisel point for concrete. Never use a broken or cracked point.
8.After each action use the pneumatic rock drill itself and its own weight as a crow bar to lever up and loosen the concrete.
9.Inspect the pneumatic rock drill and equipment regularly for defect or damage. Check that everything is in place and that all safety precautions are being followed.
10.Place the pneumatic rock drill at a slight angle leaning back towards you. By doing this you prevent the point form getting stuck in the material and the tool from getting out of control.
11.Do not pneumatic rock drill down beyond the depth of the cutting bit.
12.When leaving the pneumatic rock drill unattended shut off the air supply and relieve pressure from the supply hose before changing tool points.
13.If the pneumatic rock drill gets stuck, try to release it by moving it back and forth from side to side. If it doesn't get free, put a second bit into the pneumatic rock drill and work at stuck bit from an angle.
14.If using an electric rock drill, workers must locate the electrical cord on their shoulder to prevent accidental damages to the cord that can cause electrocution.
15.Secure hose ends to prevent whipping if an accidental cut or break occurs

How to Use A Pneumatic Rock Drill