The use of
air leg rock drills requires the rock to be drilled into a compressed air dryer. The air pressure should be maintained at 500kPa, not less than 400kPa; the air leg rock drills need to use clean soft water, as a last resort, when using acidic or alkaline water The drilling machine should be filled with some lubricating oil, and the water and air should be turned off for a short time. The new washing machine is reloaded. After the load is opened and empty, check that the operation is normal.
The
air leg rock drill time can not exceed 2 ~ 3 minutes. Too long time, the cylinder high air temperature, easy to suffer from the tank. The pipeline cleaning detachment and routine maintenance work done by the air leg rock drill are always in good working condition and keep oil, no oil-free operation. Operation attention should be the water first after opening, the wind and water pressure should be lower than the air pressure to prevent the inner cylinder from destroying the normal lubrication drilling water backflow.
From the perspective of air leg rock drills, its matching is relatively simple. If it is in a place with power supply, only one control box is needed. Where there is no power supply, a small generator can be installed. Therefore, the air leg rock drill is very simple in equipment. In addition, the air-leg rock drill saves power during use.
